User's Manual

Table Of Contents

Page26 FlexWavePrismRemoteUnitRFModuleInstallationGuide

3 AligntheMountingHookonthemodulewiththereceivingflangeonthePRUheatsink,andthenslidetheRF

Moduleintowardtheflangeuntilitcangonofurther.

RF Module

Mounting

hook

Chassis

Receiving

flange

Mounting Bracket at

back of the PRU

(View is looking down into the

PRU chassis from the top.)

4 PushtheleftedgeoftheRFModulebackandintothePRUchassisuntilitcangonofurther,asshowninthe

followinggraphics:

• ForSingle‐BayR

FModules,seeFigure15onpage27.

• ForHDMRFModul

es,seeFigure16onpage28.

• Fo

rDual‐BayRFModules,seeFigure17onpage29,whichusestheLegacyDual‐Bay40WRFModuleas

anexample.

CAUTION! MakesuretheRFModuleisseatedcorrectlyintheModuleshelf.IncorrectalignmentoftheRFModulecancausethe

RFModuletofailduetooverheating.

• ThefrontedgeoftheRFModuleshouldbeparallelwiththeshelfaboveit.

• TheMountingHookontheRFModuleshouldbefullyengagedwiththeReceivingflangeonthePRUchassis.

• IfyoulatercannotshutthePRUdoor,verifythattheRFModuleisinstalledcorrectly.