User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
Page22 FlexWavePrismRemoteUnitRFModuleInstallationGuide
©2014 TEConnectivityLtd. TECP‐77‐141Issue6 • 300001744178RevF • April2014
InstalltheRFModuleintothePrismRemoteChassis
1 HoldtheRFModulesothattheDARTcard(s)faceawayfromthePRUandtheMountingHookistowardthe
ReceivingflangeonthePRUchassis.
NOTE: Always install RF Modules from the bottom up
. Do not skip a bay, as this provides more efficient heat
dissipation.
2 Holdin
gtheRFModuleata45°angleinrespecttotherearheatsink,restthebottomsurfaceofthemodule
ontheRFModuleshelf,asshowninoneofthefollowinggraphics,andasapplicabletotheRFModule.
• Sing
le‐BayRFModule:Figure11onpage22
• HDMR
FModule:Figure12onpage23
• Dual‐BayRFModu
le:Figure13onPage24
• Le
gacyDual‐Bay40WRFModule:Figure14onPage25.
Bay C
Bay D
SeRF
Module
Bay A
Bay B
Single-Slot
RF Module
Heat Sink
Figure11.InstallingaSingle‐BayRFModule