User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
FlexWavePrismRemoteUnitRFModuleInstallationGuide Page21
TECP‐77‐141Issue6 • 300001744178RevF • April2014 ©2014 TEConnectivityLtd.
Dual‐BayModulesOnly—RemovetheModuleBayShelf
1 FORDUAL‐BAYRFMODULESONLY.
Use 9/64” Allen Wrench to
remove the three module-shelf screws
Remove Module D Shelf for
Dual-Band Dual-Slot RF Modules
Remove Module B Shelf for
Dual-Slot 40W RF Modules
IfyouareinstallingaDual‐BayRFModule,you
mustremoveamodulebayshelffromthePRU
chassis
toaccommodatethemodule’ssize.(For
furtherinformation,seeTable9onpage13.)
RemovetheshelfasappropriatefortheRF
Module:
• F
oraLegacyDual‐Bay40WRFModule,when
installingintheAandBBays,removethe
ModuleBBayShelf.
• Fo
raDual‐BayRFModule,wheninstallingin
theCandDBays,removeModuleDBayShelf.
ToremoveaModuleBayShelf:
a Use
a9/64”Allen
™
wrenchtoremovethe
threescrewsthatattachthemoduleshelfto
thePRUchassis,asshowninthefollowing
graphic.
b Discard
orstorethemoduleshelfand
fasteners.