User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
Page16 FlexWavePrismRemoteUnitRFModuleInstallationGuide
©2014 TEConnectivityLtd. TECP‐77‐141Issue6 • 300001744178RevF • April2014
Table11listshowtheFlexWavePrismEMSreferencestheRFgroupassignmentsandcorresponding
componentsofeachRFModule.
Table11
. RemoteUnitRFGroupAssignments(fromTop/Down)
Physical
RFBay
DART
Number
LNANumber
LPA
Number
forSingle
LPA
LPA
Number
forDual
LPAs
Power
Detector
Number
forSingle
PD
Power
Detector
Number
forDual
PDs
Primar
y
Diversity
D 8 8 7 8 7 8
7 7 7 7
C 6 6 5 6 5 6
5 5 5 5
B 4 4 3 4 3 4
3 3 3 3
A 2 2 1 2 1 2
1 1 1 1
NOTE: For software releases prior to 7.3, the LPAs were labeled as 1, 2, 3, and 4.
NOTE: InadualLPAsystem,theConfigureRemoteForwardGainpageshowstwovaluesfortheLPAstatus,onefor
eachLPA.ChangingtheLPAModeorresettingtheLPAappliestobothLPAsatthesametime.
CAUTION! Should your system experience an LPA problem, refer to Table 11 to ensure that you apply new settings or
troubleshootthecorrectRFModule.
CAUTION! IfyouuseacustomizedSNMPpollingforsystemstatus,youmustchangeyourLPAindexingscheme.