User's Manual

Page 20 FlexWave Prism Remote Unit RF Module Installation Guide
©2015 TE Connectivity TECP-77-141 Issue 8 • 300001744178 Rev H • September 2015
RF Module Cables and Supported Bay Installations for Legacy Dual-Bay 40W RF Modules
ͳͳǦͶͲ
Ǥ
ͳͳȋȌͶͲǦ
ǤǦ
ͳͳǤ
ǦǡMOD N TX0/RX0MOD N TX1/RX1ǡ
NǦǤǣ
• ǦǦ
ǡMOD D TX0/RX0MOD D TX1/RX1Ǥ
• ǦǦ
ǡMOD C TX0/RX0MOD C TX1/RX1Ǥ
Table 11.
Supported Bay Assignments and RF Antenna Labels for Legacy Dual-Bay 40W RF Modules
(From Top of Remote Unit Chassis Down)
Supported Bay Combinations for Legacy 40W Dual-Bay RF Modules RF Module
Cable,
RF Module
Connector, and
Remote Antenna
Connector Label
Function
Dual-Bay Tri-Bay Tri-Bay Quad-Bay
Bay D
N/A N/A N/A
MOD D
MOD D
MOD C
Mod D TX0/RX0 Transmit RF power and
primary/Path 1 receive to/from
the antenna for RF Module D
Mod D TX1/RX1 Transmit RF power and
secondary/Path 2 receive
to/from the antenna for RF
Module D
Bay C
N/A MOD C
MOD C
MOD C
Mod C TX0/RX0 Transmit RF power and
primary/Path 1 receive to/from
the antenna for RF Module C
Mod C TX1/RX1 Transmit RF power and
secondary/Path 2 receive
to/from the antenna for RF
Module C
Bay B
MOD B MOD B MOD B MOD B
MOD B
Mod B TX0/RX0 Transmit RF power and
primary/Path 1receive to/from
the antenna for RF Module B
Mod B TX1/RX1 Transmit RF power and
secondary/Path 2 receive
to/from the antenna for RF
Module B
Bay A
MOD A MOD A
Mod A TX0/RX0 Transmit RF power and
primary/Path 1 receive to/from
the antenna for RF Module A
Mod A TX1/RX1 Transmit RF power and
secondary/Path 2 receive
to/from the antenna for RF
Module A
Note: For Dual Module installations the center module shelf needs to be removed; see
“Dual-Bay Modules Only—Remove the Module Bay
Shelf” on page 25
.
Note: Install the Legacy Dual-Bay 40W RF Module in the lower-most bay in the chassis. If, however, if two Legacy Dual-Bay 40W RF Modules
are present, install the 2100 Module in the lower-most Bay and the 1900 Module in the upper-most Bay.