User's Manual

Page 30 FlexWave Prism Remote Unit RF Module Installation Guide
©2015 TE Connectivity TECP-77-141 Issue 8 • 300001744178 Rev H • September 2015
3 ǡ
Ǥ
4 ǡ
ǣ
• Ǧǡ
ͳͷ͵ͳǤ
• ǡ
ͳ͸͵ʹǤ
• Ǧǡ
ͳ͹͵͵ǡǦͶͲ
Ǥ
CAUTION! Make sure the RF Module is seated correctly in the Module shelf. Incorrect alignment of the RF Module
can cause the RF Module to fail due to overheating.
•
The front edge of the RF Module should be parallel with the shelf above it.
• The Mounting Hook on the RF Module should be fully engaged with the Receiving flange on the Remote Unit
chassis.
• An incorrectly seated RF Module makes closing the Prism door difficult. If you later cannot shut the Remote
Unit door, verify that the RF Module is installed correctly.
RF Module
Moun!ng
hook
Chassis
Receiving
flange
Moun!ng Bracket at
back of the PRU
(View is looking down into the
PRU chassis from the top.)