User's Manual
Page 46 FlexWave Prism Remote Unit RF Module Installation Guide
©2015 TE Connectivity TECP-77-141 Issue 8 • 300001744178 Rev H • September 2015
Close the Remote Unit Door and Solar Shield
1 ȄǤ
2 ȄǤ
ǡǡǦ
Ǥ
3 ȄǤ
CAUTION! Service personnel must confirm that the perimeter gasket and door-to-door gaskets are in place when
closing the Remote Unit doors after servicing.
CAUTION! If the PRU door was allowed to snap closed, RF output from an HDM RF Module may be disabled for up
to three minutes. Any alarms generated immediately following the opening/closing of the PRU Doors,
such as Door Open, RF Power Low, System VSWR Fault, and LPA VSWR Fault, automatically clear once
the RF has recovered. If alarms do not clear after three minutes, please contact TE for technical support;
see
“Contacting TE Connectivity” on page 52.
Provision the Prism Remote Unit
EMS System Setup and Provisioning Guide
Ǥ
Solar Shield
Door
Door latch