User's Manual

FlexWave Prism Remote Unit RF Module Installation Guide Page 43
TECP-77-141 Issue 8 • 300001744178 Rev H • September 2015 ©2015 TE Connectivity
Figure 24. Cable Connections for Legacy Dual-Bay 40W RF Modules
CAUTION! Ensure that all cable bends are below the top edge of the Connector Interface Panel as indicated by the
dashed line in the preceding figure. Failure to correctly position the cables could inhibit closing the
Remote Unit door, which can result in damage to the cables.
Tie wrap around
factory-installed
RX1 cable
Keep cable bends
behind the edge
of the Connector
Interface Panel