User's Manual
Table Of Contents
- Document Overview
- Overview of Prism Remote Units
- Overview of RF Modules for Prism Remote Units
- Configuring the System with RF
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Connect the Power Wiring
- Determine the Circuit Breaker or Fuse for the PRU
- (Optional) Connect the Prism Remote Unit to a UPS
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Check the DC Power Switch for the Module Bay
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables to the PRU Chassis
- Power on the RF Module(s) and the Prism Remote Unit
- Close the Remote Unit Door and Solar Shield
- Provision the Prism Remote Unit
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Fan Module Maintenance
- Specifications
- Standards Certification
- DCCS Global Technical Support
FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 108 © March 2016 CommScope, Inc.
FlexWave Notch Filter (FWP-SPRINTFILTER)
PROVISION THE PRISM REMOTE UNIT
RefertothecurrentEMSSystemSetupandProvisioningGuideforinformationonconfiguringthePRU
foraFlexWavePrismsystem.
FLEXWAVE NOTCH FILTER (FWP-SPRINTFILTER)
AFlexWaveNotchFilter(FWP-SPRINTFILTER)shipswithandisrequiredininstallationsofthe
followingRFModules:
• Dual20WSMR800/PCS1900RFModule(FWP-441T841MOD)
• Dual20W800RFModule,MIMO,SingleBay,withtwoExternalFilters(FWP-44MT000MOD).
YouinstalltheNotchFilterbetweenthePrismRemoteUnitandtheantennatoprovideprotectionfrom
spuriousemissionsinthePublicSafetybandbelow861.35MHzandtheCellularbandabove869.5MHz.
YouusethesamemountingmethodstomounttheNotchFilterasyouusedtomountthePRU.Takethe
followingintoconsiderationwhenplanningtheinstallation:
• TheNotchFilteranditsmountingbracketsrequires19inchesofverticalspaceabovethePRU(see
Figure35andFigure36onpage110).
• TheNotchFilterweighs18pounds;makesuretheinstallationsitecanbearthisadditionalweight.
• MounttheNotchFilterverticallywiththeN-typefemaleconnectorsatthebottom.
• TherearetwoGroundlugsontheNotchFilter,whichareonthebackofthetwomountingbrackets.
FollowlocalpracticetogroundtheNotchFilter.
• Thenotchfiltermustbeconnectedtothe800bandmoduleoutputbeforecombiningwithother
bandsorconnectingtoanantenna.