User's Manual

FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 107
Install the RF Module(s)
CLOSE THE REMOTE UNIT DOOR AND SOLAR SHIELD
1 Donotslamthedoortocloseit—gentlyswingthedoorshutandpressitfirmlyclosed.
2 Slowlycloseeachdoorlatchinasmoothfluidmotion—donotallowthedoorlatchestosnapclosed.
Forbestresults,startingwiththetoplatchandworkingdowntothebottomlatch,useaflat-head
screwdrivertocloseeachlatchasshownbelow.
3 DonotslamtheSolarShieldtocloseit—gentlyswingitshutandpressitfirmlyclosed.
CAUTION! Service personnel must confirm that the perimeter gasket and door-to-door gaskets are in
place when closing the Remote Unit doors after servicing.
CAUTION! If the PRU door was allowed to snap closed, RF output from an HDM RF Module may be
disabled for up to three minutes. Any alarms generated immediately following the
opening/closing of the PRU Doors, such as Door Open, RF Power Low, System VSWR Fault, and
LPA VSWR Fault, automatically clear once the RF has recovered. If alarms do not clear after
three minutes, please contact CommScope for technical support; see "DCCSGlobalTechnical
Support”onpage119.
Solar Shield Door
Door latch