User's Manual

FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 106 © March 2016 CommScope, Inc.
Install the RF Module(s)
3 FollowtheruleslistedbelowtotogglethePowerswitchthatcorrespondstoeachRFModuletoits
ONposition.
• ForDual-BandDual-BayRFModules,usethePowerswitchforthelowermodule.Forexample,
topowerupaDual-BayRFModuleincombinedbaysC+DinaQuad-Baychassis,turnONDC
PowerswitchforModC;leavetheDCPowerswitchforModDOFF.
• ALegacyDual-Bay40WRFModuleusesthePowerSuppliesinbothbays.IftheLegacyDual-Bay
40WRFModuleisinstalledinbaysC+D,turnONthePowerswitchforModCandModD.
4 VerifythattheLEDsforallinstalledRFModules(locatednexttotheirrespectiveconnectors)are
green.IfanyoftheRFModuleLEDsarenotgreen,verifythateachRFModulecableisseatedfullyin
itsrespectiveconnector.IfaftercheckingthecableconnectionsandanLEDisnotgreen,contact
CommScopeforassistance(see"DCCSGlobalTechnicalSupport”onpage119).
ForfurtherinformationonStatusLEDsonHDMRFModules,see"LEDSonNarrowbandHDMRF
Modules”onpage21and"LEDSonWidebandandFullbandHDMRFModules”onpage22.
Bay A
SeRF Module
AC/DC Power
switch for
PRU chassis
DC Power switch for Bay A
DC Power switch for Bay B
DC Power switch for Bay C
DC Power switch for Bay D
Bay B
Bay C
Bay D