User's Manual
Table Of Contents
- Document Overview
- Overview of Prism Remote Units
- Overview of RF Modules for Prism Remote Units
- Configuring the System with RF
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Connect the Power Wiring
- Determine the Circuit Breaker or Fuse for the PRU
- (Optional) Connect the Prism Remote Unit to a UPS
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Check the DC Power Switch for the Module Bay
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables to the PRU Chassis
- Power on the RF Module(s) and the Prism Remote Unit
- Close the Remote Unit Door and Solar Shield
- Provision the Prism Remote Unit
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Fan Module Maintenance
- Specifications
- Standards Certification
- DCCS Global Technical Support
FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 105
Install the RF Module(s)
POWER ON THE RF MODULE(S) AND THE PRISM REMOTE UNIT
1 Ifnecessary,poweruptheRemoteUnitbyturningitsACorDCpowerswitchtoOn.
2 EnsurethattheexternalStatusLEDonthebottomoftheRemoteUnitgoesoff.(Atsystemstartup,
theStatusLEDisredtoindicatethattheRemoteUnitispoweringupandthattheSeRFprocessor
doesnotyetcontroltheRemoteUnit;theStatusLEDwillremainredfornomorethan4minutes;
forfurtherinformationsee"RemoteUnitStatusLED”onpage10.)
NOTE: The preceding graphic illustrates the Status LED on a Quad-Bay PRU. The Status LED for the
Single-Bay, Dual-Bay, and Tri-Bay PRUs is in the same location and functions the same as the
Status LED for the Quad-Bay PRU.
Boom of an AC-Powered PRU Boom of a DC-Powered PRU
Status LED
NETWORK
POWER
48VDC/XXA
MOD D
TX1/RX1
NETWORK
MOD D
TX1/RX1
POWER
100-240 VAC
50-60 Hz
XX AMPS
WARNING:
HIGH LEAKAGE CURRENT. EARTH
CONNECTION ESSENTIAL BEFORE
CONNECTING SUPPLY
MOD D
TX0/RX0
MOD D
TX0/RX0