User's Manual

FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 104 © March 2016 CommScope, Inc.
Install the RF Module(s)
c ConnecttheLVDSCablestotheRFModule—theLVDScableslabeledPRIMandDIVshould
alwayseitherbeconnectedtoaRFModuleorstrainrelievedtoadjacentcables,asthisprotects
thecableagainstdamagethroughmisplacement.Maintainadequatestrain-reliefdistancesfrom
theconnectionpointstotheRFModule.
i ConnecttheMODNDIVLVDSCabletotheDIVreceptacleoftheRFModulebyinsertingand
slidinginuntilfullyseated.FullinsertioncanberecognizedbyanaudibleclickastheLVDS
CableConnectorlocksintotheRFModuleReceptacle.
ii ConnecttheMODNPRIMLVDSCabletothePRIMconnector,followingthesamestepsas
above.FullinsertioncanberecognizedbyanaudibleclickastheLVDSCableConnectorlocks
intotheRFModuleReceptacle.
iii EnsurethetwoLVDScablesarefullyseatedandlatchedintotheirrespectivereceptacleson
theRFModulebylightlypullingoutwardontheconnectors.Iffullyseatedandlockedinto
position,thecableconnectorswillnotslidebackout.
d ConnectthePowercabletothePWRreceptacleoftheRFModule.
i EnsurethattheDCpowerswitchthatcorrespondstothebay(s)inwhichtheRFModuleisto
beinstalledisintheOffposition(see"ChecktheDCPowerSwitchfortheModuleBay”on
page84).
ii InsertthePowercableintothePWRreceptacleofthelowerRFModulebay,andslideitin
untilfullyseated.FullinsertioncanberecognizedbyanaudibleclickasthePowercable
ConnectorlocksintotheRFModuleReceptacle.
i InsertthePowercableintothePWRreceptacleoftheupperRFModulebay,andslideitin
untilfullyseated.FullinsertioncanberecognizedbyanaudibleclickasthePowercable
ConnectorlocksintotheRFModuleReceptacle.IfthePWRreceptacleisnotavailable,
constrainthePowercabletoaccompanyingcablesusingatiewrapsoitcannotbepinched
orpreventtheRemoteUnitdoorfromclosing.
ii VerifythatthePowercableisfullyseatedbylightlypullingbackonitwhilemakingsureto
notdepressthereleasetriggersontheendsoftheconnector.Whenfullyinserted,thecable
shouldnotbeabletoberemovedfromthereceptacle.
4 Repeatallthestepsin"InstalltheRFModule(s)”onpage80toinstallotherRFModules.