User's Manual

FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 101
Install the RF Module(s)
3 ConnecttheRFModulecables,workingfromthebottomconnectorup,asdescribedbelow.
Asyouwork,refertothegraphicthatcorrespondstotheRFModulebeinginstalledintheDual-Bay:
foraDual-BayRFModule,refertoFigure33onpage102,andforaLegacyDual-Bay40WRF
Module,refertoFigure34onpage103.
a ConnecttheMODNTX1/RX1cabletotheN-StyleRFconnectorontheDual-BayRFModule(the
RFcablesandconnectorsarereferredtoasMODNTX1/RX1whereNequalsB,C,orD).
i ConstraintheMODNTX1/RX1cableofthelowerRFModulebaytoaccompanyingcables
usingatiewrapsoitcannotbepinchedorpreventtheRemoteUnitdoorfromclosing.
ii ConnecttheMODNTX1/RX1cabletotheTX1/RX1N-StyleJackoftheupperRFModuleBay.
iii Turnthecouplingnutoftheplugclockwisetothreadontothejackandfinger-tighten.
iv Torquecouplingnutto8±1in-lbstoensurefullconnection.
NOTE: Insufficient torque applied to RF Module connections can result in elevated insertion/return
loss and higher than normal VSWR reported by the system.