User's Manual

FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 64 © March 2016 CommScope, Inc.
Install the Prism Remote Unit
7 AttachthestrengthmemberfromtheFiberOpticcabletotheStrain-Relieflugontheinsidebottom
ofthePRU.
8 TightentheexternaldomenutofthePass-ThroughConnectoraroundtheFiberOpticcable—torque
thedomenutto44in-lbsplusorminus4in-lbs.
9 RoutethefibercablefromtheundersideofthePRUtotheOSPbox.
10 Followlocalpracticestosecurethefibercableinplace.
11 (Optional)OneSFPsupportsupto12timeslotswith75MHzofbandwidth.Ifasecondfibercable
assemblyisrequired(forexample,yourPrismsystemhasthreeSFPstohandleupto280MHzofRF
bandwidth),completeStep3onpage61throughStep10onpage64toaddthesecondfibercable
assembly,onlythistime,connecttotheFiber2connectorlocatedatthebottomofthePRUasshown
inStep4onpage62.
12 Returntothemaininstallationprocessandcontinueat"ConnecttheAntennaCable”onpage69.
Strain-relief lug