User's Manual

FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 86 © March 2016 CommScope, Inc.
Install the RF Module(s)
INSTALL THE RF MODULE INTO THE PRISM REMOTE CHASSIS
1 HoldtheRFModulesothattheDARTcard(s)faceawayfromthePRUandtheMountingHookis
towardtheReceivingflangeonthePRUchassis.
NOTE: Always install RF Modules from the bottom up. Do not skip a bay, as this provides more
efficient heat dissipation.
2 HoldingtheRFModuleata45°angleinrespecttotherearheatsink,restthebottomsurfaceofthe
moduleontheRFModuleshelf,asshowninoneofthefollowinggraphics,andasapplicabletothe
RFModule.
• Single-BayRFModule:Figure21onpage86
• HDMRFModule:Figure22onpage87
• Dual-BayRFModule:Figure23onpage88
• LegacyDual-Bay40WRFModule:Figure24onpage89.
Figure 21. Installing a Single-Bay RF Module
Bay C
Bay D
SeRF
Module
Bay A
Bay B
Single-Slot
RF Module
Heat Sink