User's Manual

FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 85
Install the RF Module(s)
DUAL-BAY MODULES ONLY—REMOVE THE MODULE BAY SHELF
FORDUAL-BAYRFMODULESONLY.
IfyouareinstallingaDual-BayRFModule,
youmustremoveamodulebayshelffrom
thePRUchassistoaccommodatethe
module’ssize.(Forfurtherinformation,see
Table16onpage27.)
RemovetheshelfasappropriatefortheRF
Module:
• WheninstallingintheAandBBays,
removetheModuleBBayShelf.
• WheninstallingintheCandDBays,
removeModuleDBayShelf.
ToremoveaModuleBayShelf:
1 Usea9/64”Allen
™
wrenchtoremove
thethreescrewsthatattachthemodule
shelftothePRUchassis,asshowninthe
graphictotheright.
2 Discardorstorethemoduleshelfand
fasteners.
Use 9/64” Allen Wrench to
remove the three module-shelf screws
Remove Module D Shelf for
Dual-Band Dual-Slot RF Modules
Remove Module B Shelf for
Dual-Slot 40W RF Modules