User's Manual

Table Of Contents

FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide

Install the Prism Remote Unit

A4-WireM8picofast

6-or10-meter26AWGcableisusedtoconnectthePRUtotheexternaldevice,

asshowninFigure18.

Figure 18. 4-Wire picofast 26 AWG Cable

DothefollowingtoconnectaUPStotheAUXConnectoronthebottomofthePRU:

1 Obtaintherequiredlengthof6-or10-meterpicofastcable.

2 Orientthecouplingfasteneronthecable(Figure18)withtheAUXConnectorpins(Figure17),and

thenfastenthecabletotheAUXConnector.

3 RoutethecablefromthePRUAUXConnectortotheUPS(ifnotalreadyrouted)andthencuttothe

requiredlength.Allowsufficientslackfordressingandorganizingthecableattheexternaldevice.

4 Stripbacktheoutercablesheathandinsulationtoexposethewiresattheendofthecableandstrip

back0.2inches(5mm)ofinsulationfromeachwire.

5 Connectthealarmwirepairstotheappropriateterminalsontheexternaldevice.

6 Dressandsecurecableperstandardindustrypractice.

NOTE: If necessary, order a Prism AUX 4-wire cable assembly, CommScope part number 1451903.

Strip cable

0.2 inches (5 mm)

Connect 4 wires to UPS

Connect to

PRU AUX Connector