User's Manual
Table Of Contents
- Document Overview
- Overview of Prism Remote Units
- Overview of RF Modules for Prism Remote Units
- Configuring the System with RF
- Install the Prism Remote Unit
- Planning for a Prism Remote Unit Installation
- Unpack and Inspect the Prism Remote Unit and Components
- Mount the Prism Remote Unit
- Ground the PRU Chassis
- Connect a Network Cable to the PRU Chassis
- Connect Fiber Cable to the PRU Chassis
- Connect the Antenna Cable
- Connect the Power Wiring
- Determine the Circuit Breaker or Fuse for the PRU
- (Optional) Connect the Prism Remote Unit to a UPS
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Check the DC Power Switch for the Module Bay
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables to the PRU Chassis
- Power on the RF Module(s) and the Prism Remote Unit
- Close the Remote Unit Door and Solar Shield
- Provision the Prism Remote Unit
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Fan Module Maintenance
- Specifications
- Standards Certification
- DCCS Global Technical Support
FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 73
Install the Prism Remote Unit
Option 2: Connect the DC Power Wiring
NOTE: All electrical work must comply with local codes and requirements. A locally licensed
electrical contractor is best qualified to perform this work. For additional information, consult
with the CommScope Technical Support for Wireless Products team (see "DCCSGlobal
TechnicalSupport”onpage119).
1 ObtainaDCpowercablethatmeetsthefollowingrequirements:
• TheDCpowercablecanbe8AWGor6AWG,3-or4-conductorpowercableratedforoutdoor
use.
• Thewirecolorsmustbegreen,red,andblack.
• Thecablemustbebetween.71-inchto.98-inchindiameter.
• Ifa4-conductorpowercableisused,theextraconductorcanbesnippedoffbeforeinstallation.
• Ifusing6AWGwire,theinstallermustprovideanduse#10studsize,6AWGringterminals.
2 Removethecable-glandplugfromthebottomofthePRUchassis:
Cable-gland plug