User's Manual

FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 60 © March 2016 CommScope, Inc.
Install the Prism Remote Unit
3 CleantheMulti-FiberOpticcableconnectorusingindustryapprovedcleaningprocedures.
4 CleantheFiber1portusingindustryapprovedcleaningprocedure.
5 InserttheMulti-Fiber
Opticcableintothe
FIBER1connector;
refertothe
introductorymaterial
forthissectionfor
informationoncabling
requirements.
a Aligntheplugendof
thecablewiththe
keyasindicatedon
theoverlayforthe
FIBER1connector,
asshownbelow.
b Usea9/16”wrench
torotatethe
couplingnut
clockwise;tightento
2-4in-lbs.
6 RoutetheMulti-Fiber
Opticcablefromthe
undersideofthePRUto
theOSPbox.
7 Securefibercablein
placefollowinglocal
practices.
8 Ifnecessary,complete
Step1throughStep7to
addasecond
Multi-FiberOpticcable
totheFIBER2connector.
9 Continueto"ConnecttheAntennaCable”onpage69.
Mul-fiber opc cable
AC or DC PRU
(The Fiber 1 and Fiber 2 connectors are in the same
locaon for both the AC- and DC-powered PRUs.)