User's Manual

FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 59
Install the Prism Remote Unit
UsethefollowingproceduretoinstallthefibercablesusingtheHMFOC.
1 Usea7/16”wrenchorsockettoremovethedust-covercapfromtheFiber1connector,locatedat
thebottomofthePRU.Youneedtoturnthecapcounter-clockwiseforseveralturns.
NOTE: Do not remove the dust cover from the Fiber 2 connector until directed to do so.
2 RotatethecouplingnutoftheMulti-FiberOpticcablecounter-clockwisetoremoveitsdust-cover
cap.
AC or DC PRU
Fiber 1
Fiber 2
(The Fiber 1 and Fiber 2 connectors are in the same
locaon for both the AC- and DC-powered PRUs.)
Coupling nut