User's Manual
Table Of Contents
- Document Overview
- Overview of Prism Remote Units
- Overview of RF Modules for Prism Remote Units
- Configuring the System with RF
- Install the Prism Remote Unit
FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 55
Install the Prism Remote Unit
CONNECT FIBER CABLE TO THE PRU CHASSIS
TherearethreefiberconnectoroptionsforthePrismRemoteUnit;followthefibercableinstallation
processthatisappropriatefortheconfigurationofthePRUthatyouareinstalling:
• "OptionA:HardenedMulti-FiberOpticConnector”onpage55
• "OptionB:FiberPass-ThroughConnector”onpage61
• "OptionC:ProAxConnector(LegacyAC-PoweredPRUs)”onpage65.
Option A: Hardened Multi-Fiber Optic Connector
NOTE: Use the following procedure to install the fiber cables using a Hardened Multi-Fiber Optic
Connector. If the PRU that you are installing has a Fiber Pass-Through Connector, follow the
procedure in "Option B: Fiber Pass-Through Connector” on page 61. If the PRU that you are
installing has a legacy ProAx Connector, follow the procedure in "Option C: ProAx Connector
(Legacy AC-Powered PRUs)” on page 65.
PRUsnowhaveaHardenedMulti-FiberOpticConnector(HMFOC),asshowninthe
pictureattheright.
AllPRUswiththeHMFOCconfigurationrequirethepurchaseofaMulti-FiberOptic
Cable,suchastheoneshownbelow,whichallowsthePRUtointerfacewiththeOSPfiber.