User's Manual

FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 54 © March 2016 CommScope, Inc.
Install the Prism Remote Unit
2 RoutethenetworkcablefromthenetworkconnectiontotheundersideofthePRU.
3 AligntheplugendoftheRJ-45cableconnectorwiththeRJ-45portreceptacleandtheninsertthe
cableplugintotheportreceptacle.
4 Slidetheconnectornutuptotheportuntilitengagestheconnectorlockingmechanism.
5 Tightentheconnectornutinaclockwisedirection(ifnecessary,useawrenchtogriptheconnector
nut)untilitsnapspasttheindentedpositionandlocksintoplace.Itmaybenecessarytoapply30to
50in-lbs(3.4to5.6Nm)oftorquetotheconnectornutinordertoturnitpasttheindentedposition.
DC-Powered PRU
AC-Powered PRU