User's Manual

FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 51
Install the Prism Remote Unit
Installing a PRU on the Mounting Bracket
ThebasicproceduretohangaPRUonaMountingBracketisthesame.Theillustrationsinthis
procedure,however,showapole-mountinstallation.
1 Referto"MountingCautions”onpage42beforebeginningthisprocess.
2 UsetheD-RingsonthetopofthePRUtohoistthePRUintopositionforattachmenttotheMounting
Bracket.
CAUTION! To avoid damage to the PRU and to avoid personal injury, use appropriate lifting equipment.
3 MatethemountinghooksonthebackofthePRUwiththe8horizontalhanging-bracketpinsonthe
MountingBracketasshownbelow.
4 LowerthePRUuntiltheMountingCaponthetopofthePRUissnugagainstthetopoftheMounting
Bracket.
5 Usetheflat-bladescrewdrivertosecurethetwocaptivefastenersonthebottomofthePRUtothe
MountingBracket.
Mounng
hooks (8)
Hanging-Bracket
Pins (8)
D-Rings
Mounng Cap