User's Manual

FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 50 © March 2016 CommScope, Inc.
Install the Prism Remote Unit
7 Refertoanchormanufacturer'stechnicaldatatoensureproperdrilldiametertobeused,andthen
drillholesinthewallatthelocationsmarkedinStep6.
8 Refertothefollowingfigureanddothefollowing:
a Settheanchorsinthewall.
b Locatethetwo1/2x1-1/2-inchmountingboltsandplacea1/2-inchlockwasherand1/2-inch
flatwasheroneachbolt.
c PlacetheMountingBracketoverthetwoanchors.Threada1/2x1-1/2-inchmountingbolt
(withinstalledwashers)intoeachoneoftheanchors.Tightenboltsuntilsecure.
9 HangthePRUfromtheMountingBracketasshownin"InstallingaPRUontheMountingBracket”on
page51.
1/2-inch flat washer
Masonry Wall
1/2-inch Concrete
anchors
1/2 x 1-1/2-inch Hex bolt
1/2-inch Lock washer
Mounng bracket
1/2 x 1-1/2-inch Hex bolt
1/2-inch flat washer
1/2-inch Lock washer