User's Manual

FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 49
Install the Prism Remote Unit
Masonry Wall Mounting
1 Referto"MountingCautions”onpage42beforebeginningthisprocess.
2 LocatetheMountingBracketprovidedwiththePRUMountingKit.
3 Obtainthetoolsandsupplieslistedin"ToolsRequiredforAllMountingMethods”onpage36and
"AdditionalToolsandSuppliesRequiredforFlat-SurfaceMounting”onpage37.
4 Verifythatconcreteanchorstobeusedaredesignedfor1/2-inchbolts.
5 HoldtheMountingBracketinpositiononthewall.
6 Usingapencil,markthelocationofeachoftheMountingBracket’stwomountingholesonthewall.
WhenmountingthePRUonamasonrysurface,locatethemountinganchorsascloseaspossibleto
thecenterofanybricksorblocks,especiallytheupperanchors.
Masonry Wall
Prism Remote Unit
Mounng Bracket
Mark the locaon of the
two mounng holes