User's Manual

FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 48 © March 2016 CommScope, Inc.
Install the Prism Remote Unit
8 Drill9/16-inchholesintheplywoodbackerattheholepositionsmarkedinStep7.
9 Refertothefollowingfigureanddothefollowing:
a Fromthesideofthebackerthatwillfacethewall,drivea1/2-inchTeeNutintoeachdrilledhole.
b Mounttheplywoodbackeronthewallandfirmlysecureittothewall’sinteriorstuds.
c Locatethetwo1/2x1-inchhexboltsandplacea1/2-inchlockwasherand1/2–inchflatwasher
oneachboltandthensecuretheMountingBrackettotheplywoodbackerusingtheassembled
boltsandwashers.
CAUTION! If plywood backer board or supporting wall is not smooth or does not provide a flat mounting
plane for the PRU, add 1/2-inch flat washers between the Mounting Bracket and the
mounting surface as required to prevent the PRU from twisting or distorting when secured to
the mounting surface.
10 HangthePRUfromtheMountingBracketasshownin"InstallingaPRUontheMountingBracket”on
page51.
Tee Nut
3/4-inch Plywood
backer board
(secure to wall studs)
1/2 x 1-1/2-inch
Hex bolt
1/2-inch Flat
washer
1/2-inch Lock
washer
1/2 x 1-1/2-inch
Hex bolt
1/2-inch Flat
washer
1/2-inch Lock
washer
Prism Remote Unit
Mounng Bracket