User's Manual

FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 47
Install the Prism Remote Unit
Wood-Framed Wall Mounting Procedure
1 Referto"MountingCautions”onpage42beforebeginningthisprocess.
2 LocatetheMountingBracketprovidedwiththePRUMountingKit.
3 Obtainthetoolsandsupplieslistedin"ToolsRequiredforAllMountingMethods”onpage36and
"AdditionalToolsandSuppliesRequiredforFlat-SurfaceMounting”onpage37.
4 Obtainplywoodwithaminimumthicknessof0.75-inches(19.0cm)tobeusedasabackerboard.
CAUTION! If the PRU is installed in an area in which there may be moisture, use pressure-treated
plywood.
5 Cutthepressure-treatedplywoodtothecorrectsizetoaccommodatethePRUbeinginstalled(see
dimensionsinTable19onpage31).
6 Toavoidahazardouscondition,firmlysecurethebackerboardtotheinteriorframingofthewall.
7 HoldtheMountingBracketuptothewallandmarkthelocationoftheMountingBracket’stwo
mountingholesontheplywoodbacker:
3/4-inch Plywood
Backer Board
(secure to wall studs)
Mounng
Bracket
Mark the locaon
of the two mounng
holes