User's Manual

FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 44 © March 2016 CommScope, Inc.
Install the Prism Remote Unit
BandsshouldpassthrougheachslotoftheMountingBracket,fromtoptobottom,ensuringtheband
passesoverthetopofthepins,asshownbelow,andagainthroughthebuckle.
4 Wrapthebandaroundpoleoncemore,passingthroughtheslotsintheMountingBracketandover
pins,andagainthroughbuckle.Doublebandingiscriticaltogeneratemaximumradialcompression
ofbandingtopoleandMountingBracket.
5 Followspecificmanufacturer'sinstructionsfortensioningbandstorecommendedlevels.
6 Rolltoolover,bendingbandoveritselfatexitfromthebuckle,asshownabove,orasinstructedin
themanufacturer'sinstructionstotemporarilysecuretensionedband.
7 Cutbandusingtensioningtoolasinstructedinthemanufacturer'sinstructions.