User's Manual

FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 36 © March 2016 CommScope, Inc.
Install the Prism Remote Unit
Installation Tools and Supplies
ThetoolsandanyadditionalmaterialsrequiredforinstallandmountthePRUaredependentonthe
mountinglocation.
Tools Required for All Mounting Methods
TheMountingBracketshipswiththePRU—itsecuresthePRUtoitspackingcrate.Allinstallations
requireatleastoneeachofthefollowing,whichmustbeprovidedbytheinstaller:
• tapemeasure
• pencilorothermarkingdevice
• 3/8-inchFlat-Bladescrewdriver
• liftingequipmentforPRU.
Additional Tools and Supplies Required for Steel-Pole Mounting
WhenmountingthePRUtoasteelpole,inadditiontothesupplieslistedin"ToolsRequiredforAll
MountingMethods”onpage36thefollowingsuppliesareneeded:
• onehammer,>16-ounces
• oneStrapTensioning/ClampingTool(UlineModelNo.H-1273,orequivalent)
• Table20showsthenumberofstainless-steelstrapsandstainless-steelbucklesrequiredforeach
PRUtype,inwhichyoumusthavethesamenumberofbucklesasstraps.
– Use1/2-inchto3/4-inch201,301,304or316Stainless-SteelStrappingwithaminimumtensile
strengthof1500lbs(UlineModelNo.S-11329,orequivalent).
– UseStainless-SteelBucklesdesignedspecificallyfortheabovementionedstrapping(Uline
ModelNo.S-11331,orequivalent).
Table 20. Required Stainless-Steel Bands for Steel-Pole Mounting
CommScope Catalog Number Number of Bands Required for Installation
FP4-XXXXX0021XXRU - Quad-Bay Remote
4
FP3-XXXXX0021XXRU - Tri-Bay Remote
3
FP2-XXXXX0021XXRU - Dual-Bay Remote
FP1-XXXXX0021XXRU - Single-Bay Remote
2