User's Manual

FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 25
Configuring the System with RF
TheLegacyDual-Bay40WRFModuleoccupiestwobaysinaPRU.Figure8showsthemaincomponents
inaPRUenclosure,withaLegacy40WRFModuleoccupyingBaysAandB.ThecontrollingDARTwill
alwaysbeintheupperbay(BorD),andthesecondLPAisalwaysinthelowerbay(AorC).
Figure 8. Legacy Dual-Bay 40W RF Module in a Quad-Bay PRU
NOTE: If a Legacy Dual-Bay 40W RF Module AWS 2100 and a Legacy Dual-Bay 40W RF Module PCS
1900 are both installed in a Quad-Bay PRU, it is recommended that the PCS 1900 be installed
in upper-most bay, and the AWS 2100 be installed in the lower-most bay.
NOTE: To accommodate two-bay modules, you need to remove a module bay shelf as described in
"Dual-Bay Modules Only—Remove the Module Bay Shelf” on page 85.
Legacy Dual-Bay 40W RF Module
in Bay B (upper slot) and
Bay A (lower slot) with the
controlling DART in Bay B
AC or DC power switch
Four DC power switches
SeRF Module and Power supplies
Bay C (empty for future use)
Bay D (empty for future use)
Fans
Connecvity panel with Status LED