User's Manual

FWPP-501-01 Issue 1320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide
© March 2016 CommScope, Inc. Page 19
Overview of RF Modules for Prism Remote Units
Linear Power Amplifiers
TheLinearPowerAmplifier(LPA)isahighqualitybroadbandRFamplifierusedforachievingPrism
product-ratedpowerfortheRemoteUnitTxforwardpathRF.ThePAsarepass-bandspecific,withthe
maximumcompositeTxpowerlevelslistedinTable13forSingle-Card,Dual-Card,andHDMRF
ModulesandTable14onpage20forLegacyDual-Bay40WRFModules.
TheLPAishousedwithintheRFModule,andisnotfieldserviceable.
Table 13. LPA Maximum Composite Tx Power Levels for Single-Card, Dual-Card, and HDM RF Modules
Bandwidth (MHz) supported across entire spectrum*
Passband
Maximum
dB
m
Watts
HDM
Single Super DART
Classic
DART
Dual
Su
perDART
Dual/MIMO SISO
700 LTE Lower ABC 43 20 18 18 18 NA NA
700 LTE Upper C
43 20 10 10 10 NA NA
4
6 40 10 10 10 NA NA
800 SMR 43 20 7 7 NA 18 NA
850 Cellular
43 20 25 25 NA 25 NA
46
40 25 25 NA 25 NA
900 EGSM 40 10 35 35 35 NA NA
900 PGSM 40 10 25 25 25 NA NA
900 SMR 38 6.5 NA NA NA 5 NA
1800 DCS 42 15.8 35 NA 39 NA 75
1900 PCS 43 20 35 65 39 NA 70
4
6 40 NA 65 39 NA 70
2100 AWS
43 20 35 45 39 NA 45
4
6 40 NA 45 39 NA 45
2100 UMTS 42 15.8 35 NA 39 NA 60
2300 WCS 43 20 10 10 10 NA NA
2500 TDD Low
2500 TDD High 43 20 NA 75 75 NA 75
* The International bands (1800 DCS, 2100 UMTS, 2600 MIMO) Dual/MIMO RF Modules only support 35 MHz contiguous, as
op
posed to 35 MHz non-contiguous for PCS and AWS Dual/MIMO RF Modules.