User's Manual
Table Of Contents
- Document Overview
- Overview of Prism Remote Units
- Overview of RF Modules for Prism Remote Units
- Configuring the System with RF
- Install the Prism Remote Unit
FlexWave Prism Remote Unit and HDM RF Module Installation Guide 320000117795 Rev A • FWPP-501-01 Issue 1
Page 16 © March 2016 CommScope, Inc.
Overview of RF Modules for Prism Remote Units
HDM RF Modules
High-DensityModule(HDM)RFModules(Figure3)aredesignedtoprovidetheabilitytodeployeither
atwo20WMultipleInputMultipleOutput(MIMO)pathsofthesameband,knownasaMIMORF
Module;two20WSingleInputSingleOutput(SISO)withtwodifferentbands,knownasdualRFModule;
orasingle40WSingleInputSingleOutput(SISO)RFModulewithinasingle-bayofaPRU.
Figure 3. HDM RF Modules
AnHDMRFModuledoesthefollowing:
• interfaceswithoneHostDART-eitherClassicorSuperDART,oroneCDIU
• supportstwonon-contiguousRFslicesupto35MHztotalbandwidthinaDualorMIMO
configuration
• supportsfullbandwidthinaSISOconfiguration,upto75MHz
• supports20Wperband/PathinaDual/MIMORFModule
• supportsupto40WRFoutputpowerinaSISORFModule.
ThecomponentsofaPRUHDMRFModulearedependentonthemoduletype,aslistedinTable12.
Table 12. Components of PRU HDM RF Modules
RF Module Type DPM LPA Duplexer LNA Power Detector Rx Card Tx Card
SISO 11 1 1 1 1 1
MIMO/Dual Band Module 12 2 2 2 2 2