User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- RF Group Assignments for PRU RF Module Bays
- Understanding RF Cable Rules
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Check the DC Power Switch for the Module Bay
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables to the PRU Chassis
- Power on the RF Module(s) and the Prism Remote Unit
- Close the Remote Unit Door and Solar Shield
- Provision the Prism Remote Unit
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
FlexWave Prism Remote Unit RF Module Installation Guide Page 9
TECP-77-141 Issue 8 • 300001744178 Rev H • August 2015 ©2015 TE Connectivity
RF Module Types
The Remote Unit RF Modules are available in the following formats, and as described in the following sections:
• “Single- and Dual-Bay RF Modules with Classic or SuperDARTs” on page 9
• “HDM RF Modules” on page 10
• “Legacy Dual-Bay 40W RF Modules” on page 11.
Single- and Dual-Bay RF Modules with Classic or SuperDARTs
Figure 2 shows examples of Single- and Dual-Bay RF Modules, both of which have two DARTs.
Single-Bay RF Modules have the
foll
owing elements:
• o
ne or two DARTs
• o
ne Duplexer that comprises
– o
ne Low Noise Amplifier (LNA)
– one Pow
er Detector (PD)
• one Linear Power Amp
lifier (LPA)
Dual-Band Dual-Bay RF Modules have the
foll
owing elements:
• two DARTs
• two Duplexers, eac
h of which
comprises
– o
ne Low Noise Amplifier (LNA)
– one Pow
er Detector (PD)
• o
ne Linear Power Amplifier (LPA)
• on
e Remote DART Interface (RDI)
board.
Dual-Band Dual-Bay RF Module
Single-Bay Dual-Card RF Module
Figure 2. Single- and Dual-Bay RF Modules
• on
e Remote DART Interface (RDI)
board.