User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- RF Group Assignments for PRU RF Module Bays
- Understanding RF Cable Rules
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Check the DC Power Switch for the Module Bay
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables to the PRU Chassis
- Power on the RF Module(s) and the Prism Remote Unit
- Close the Remote Unit Door and Solar Shield
- Provision the Prism Remote Unit
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
Page 34 FlexWave Prism Remote Unit RF Module Installation Guide
©2015 TE Connectivity TECP-77-141 Issue 8 • 300001744178 Rev H • August 2015
Secure RF Module Latches
1 To secure the module latches on the left side of the RF Module, do one of the following, as appropriate for the
RF Module being installed:
• “Connect Latches on Single-Bay and HD
M RF Modules” on page 34
• “Connect Latches on Dual-Bay RF Modules” on page 35.
Connect Latches on Single-Bay and HDM RF Modules
For Single-Bay and HDM RF Modules, secure two latches, as shown in Figure 18.
Two latches on Single-Slot
RF Modules
Two latches on
HDM RF Modules
Figure 18. Latches on Single-Bay and HDM RF Modules