User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- RF Group Assignments for PRU RF Module Bays
- Understanding RF Cable Rules
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Check the DC Power Switch for the Module Bay
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables to the PRU Chassis
- Power on the RF Module(s) and the Prism Remote Unit
- Close the Remote Unit Door and Solar Shield
- Provision the Prism Remote Unit
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
Page 12 FlexWave Prism Remote Unit RF Module Installation Guide
©2015 TE Connectivity TECP-77-141 Issue 8 • 300001744178 Rev H • August 2015
RF MODULE COMPONENTS
Figure 5 shows typical RF Module components, using the Single-Bay RF Module as an example.
Mounng
latch
Mounng hook
Duplexer
Power Amplifier (PA)
DARTs
NOTE: The RDI is internal to the RF Module and is therefore not shown.
LNA
(inside the Duplexer caviy)
Figure 5. Single-Bay RF Module Components
Figure 6 shows the components of an HDM RF Module.
Duplexers
Power Amplifier
Mounng latch
Mounng hook
Tx and Rx Cards
DPM
Figure 6. HDM RF Module Components