User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- RF Group Assignments for PRU RF Module Bays
- Understanding RF Cable Rules
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Check the DC Power Switch for the Module Bay
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables to the PRU Chassis
- Power on the RF Module(s) and the Prism Remote Unit
- Close the Remote Unit Door and Solar Shield
- Provision the Prism Remote Unit
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
Page 10 FlexWave Prism Remote Unit RF Module Installation Guide
©2015 TE Connectivity TECP-77-141 Issue 8 • 300001744178 Rev H • August 2015
HDM RF Modules
High-Density Module (HDM) RF Modules (Figure 3) are designed to provide the ability to deploy either a two
20W Multiple Input Multiple Output
(MIMO) paths of the same band, known as a MIMO RF Module; two 20W
Single Input Single Output (SISO) with two different bands, known as dual RF Module; or a single 40W Single
Input Single Output (SISO) RF Module within a single-bay of a PRU. An HDM RF Module does the following:
• interfaces with on
e Host DART-either Classic or SuperDART, or one CDIU
• supports two non-contigu
ous RF slices up to 39 MHz total bandwidth in a Dual or MIMO configuration
• supports full bandwidth in a SISO configuratio
n, up to 75 MHz
• supports
20W per band/Path in a Dual/MIMO RF Module
• supports
up to 40W RF output power in a SISO RF Module.
The components of a PRU HDM RF Module are dependent on the module typ
e, as listed in Table 7.
Table 7.
Components of PRU HDM RF Modules
RF Module Type
DPM LPA Duplexer LNA
Power
Detector
Rx Card Tx Card
SISO 1 1 1 1 1 1 1
MIMO/Dual Band Module 1 2 2 2 2 2 2
Figure 3. HDM RF Modules