User's Manual

FlexWavePrismRemoteUnitRFModuleInstallationGuide Page9
TECP‐77‐141Issue6 • 300001744178RevF • July2014 ©2014TEConnectivity
HDMRFModules
HDMRFModules(Figure3)aredesignedtoprovidetheabilitytodeployeithera20WDual/MultipleInput
multipleOutput(MIMO)RFModule(wheredualequalstwobands)o
ra40WSingleInputSingleOutput(SISO)
RFModulewithinasingle‐bayofaPRU.AnHDMRFModuledoesthefollowing:
• interfaceson
eHostDART‐eitherClassicorSuperDART
• suppo
rtstwonon‐contiguousRFslicesupto35MHztotalbandwidthinaDualorMIMOconfiguration
• suppo
rtsfullbandwidthinaSISOconfiguration,upto75MHz
• suppo
rts20Wperband/PathinaDual/MIMORFModule
• suppo
rtsupto40WRFoutputpowerinaSISORFModule.
AnHDMRFModulehasthefollowingcomponents:
• oneDPM
• oneortwosetsof
TX/RXboards
• oneortwoDuplexers
• oneortwoPow
erAmplifiers(PAs).
Figure3.HDMRFModules
ThecomponentsofaPRUHDMRFModulearedependentonthemoduletype
,aslistedinTable7.
Table7.
ComponentsofPRUHDMRFModules
RFModuleType DPM LPA Duplexer RxCard TxCard
SISO 1 1 1 1 1
MIMO/DualBan
dModule 1 2 2 2 2