User's Manual

Table Of Contents

Page36 FlexWavePrismRemoteUnitRFModuleInstallationGuide

ConnectingCablesinaSingle‐BayRFModuleInstallation

1 PositionthecablessothattheyareundertherightedgeoftheRFModule,pointingup.

2 Followtheruleslistedin“UnderstandingtheRFModuleCables”onpage14.

3 ConnecttheRFModulecables,inthefollowingorder:

a ConnecttheMODNTX0/RX0cabletotheRFModule.

i InserttheN‐StylePlugoftheMODNTX0/RX0cableintotheTX0/RX0N‐StyleJackoftheRFModule.

ii Turnthecouplingnutoftheplugclockwisetothreadontothejackandfinger‐tighten.

iii Torquecouplingnutto8±1in‐lbstoensurefullconnection.

NOTE: InsufficienttorqueappliedtoRFModuleconnectionscanresultinelevatedinsertion/returnlossand

higherthannormalVSWRreportedbythesystem.

b ConnecttheMODNTX1/RX1cabletotheRFModule.

i IfaTX1/RX1RFModuleconnectionisavailable,inserttheN‐StylePlugoftheMODNTX1/RX1cable

intotheTX1/RX1N‐StyleJackoftheRFModule.IfRFModuleconnectionisnotavailable,constrain

theMODNTX1/RX1cabletoaccompanyingcablesusingatiewrapsoitcannotbepinchedorprevent

thePRUdoorfromclosing.

ii Turnthecouplingnutoftheplugclockwisetothreadontothejackandfinger‐tighten.

iii Torquecouplingnutto8±1in‐lbstoensurefullconnection.

NOTE: InsufficienttorqueappliedtoRFModuleconnectionscanresultinelevatedinsertion/returnlossand

higherthannormalVSWRreportedbythesystem.

c ConnecttheLVDSCablestotheRFModule.

i ConnecttheMODNDIVLVDSCabletotheDIVreceptacleoftheRFModulebyinsertingandsliding

inuntilfullyseated.

NOTE: AlwaysconnecttheDiversityLVDSCablewiththeRFModule.

ii ConnecttheMODNPRIMLVDSCabletothePRIMconnector,followingthesamestepsasabove.

NOTE: FullinsertioncanberecognizedbyanaudibleclickastheLVDSCableConnectorlocksintotheRF

ModuleReceptacle.ThiscanbeverifiedbylightlypullingbackontheLVDSconnectorwhilemakingsure

notto

depressthereleasetrigger.Whenfullyinserted,thecableshouldnotbeabletoberemovedfrom

thereceptacle.

d ConnectthePowerCableConnectortothePWRreceptacleoftheRFModulebyinsertingandslidingin

untilfullyseated.

NOTE: FullinsertioncanberecognizedbyanaudibleclickasthePowerCableConnectorlocksintotheRF

ModuleReceptacle.ThiscanbeverifiedbylightlypullingbackonthePowerCableConnectorwhile

makingsurenottodepressthereleasetriggersontheendsoftheconnector.Whenfullyinserted,

the

cableshouldnotbeabletoberemovedfromthereceptacle.