User's Manual

FlexWavePrismRemoteUnitRFModuleInstallationGuide Page35
TECP‐77‐141Issue6 • 300001744178RevF • July2014 ©2014TEConnectivity
LatchesonLegacyDual‐Bay40WRFModules
ForLegacyDual‐Bay40WRFModules,securefourlatches,asshowninFigure20.
Four latches in a
Legacy Dual-Slot 40W
RF Module
Figure20.LegacyDual‐Bay40WRFModuleLatches
VerifythattheRFModuleMountingHookisEngaged
1 VerifythattheRFModuleMountingHookisengagedcorrectlybypullingthemoduleawayfromtheheatsink.
TheRFModuleshouldnotmove.IftheRFModulemovesduringthischeck,repeatallthestepsstartingat
“InstalltheRFModuleintothePrismRemoteChassis”onpage25throughthisstep.
ConnecttheRFModuleCables
ThestepstoconnecttheRFModulecableshavebeenseparatedintotwodifferentprocedures;followthesteps
thatcorrespondtotheRFModulebeinginstalled.
• “ConnectingCablesinaSingle‐BayRFModuleInstallation”onpag
e36
• “Connect
ingCablesinaDual‐BayRFModuleInstallation”onpage39.