User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
FlexWavePrismRemoteUnitRFModuleInstallationGuide Page33
TECP‐77‐141Issue6 • 300001744178RevF • July2014 ©2014TEConnectivity
SecureRFModuleLatches
1 TosecurethemodulelatchesontheleftsideoftheRFModule,dooneofthefollowing,asappropriateforthe
RFModulebeinginstalled:
• “ConnectLatchesonSingle‐Bayan
dHDMRFModules”onpage33
• “ConnectLatchesonDual‐BayRFModules”onpage34.
ConnectLatchesonSingle‐BayandHDMRFModules
ForSingle‐BayandHDMRFModules,securetwolatches,asshowninFigure18.
Two latches on Single-Slot
RF Modules
Two latches on
HDM RF Modules
Figure18.Latches onSingle‐BayandHDMRFModules