User's Manual

FlexWavePrismRemoteUnitRFModuleInstallationGuide Page29
TECP‐77‐141Issue6 • 300001744178RevF • July2014 ©2014TEConnectivity
3 AligntheMountingHookonthemodulewiththereceivingflangeonthePRUheatsink,andthenslidetheRF
Moduleintowardtheflangeuntilitcangonofurther.
RF Module
Mounting
hook
Chassis
Receiving
flange
Mounting Bracket at
back of the PRU
(View is looking down into the
PRU chassis from the top.)
4 PushtheleftedgeoftheRFModulebackandintothePRUchassisuntilitcangonofurther,asshowninthe
followinggraphics:
• Fo
rSingle‐BayRFModules,seeFigure15onpage30.
• F
orHDMRFModules,seeFigure16onpage31.
• Fo
rDual‐BayRFModules,seeFigure17onpage32,whichusestheLegacyDual‐Bay40WRFModuleas
anexample.
CAUTION! MakesuretheRFModuleis seatedcorrectlyintheModuleshelf.IncorrectalignmentoftheRFModulecancause
theRFModuletofailduetooverheating.
• ThefrontedgeoftheRFModuleshouldbeparallelwiththeshelfaboveit.
• TheMountingHookontheRFModuleshouldbefullyengagedwiththeReceivingflangeonthePRUchassis.
• IfyoulatercannotshutthePRUdoor,verifythattheRFModuleisinstalledcorrectly.