User's Manual

Page24 FlexWavePrismRemoteUnitRFModuleInstallationGuide
©2014TEConnectivity TECP‐77‐141Issue6 • 300001744178RevF • July2014
Dual‐BayModulesOnly—RemovetheModuleBayShelf
1 FORDUAL‐BAYRFMODULESONLY.
Use 9/64” Allen Wrench to
remove the three module-shelf screws
Remove Module D Shelf for
Dual-Band Dual-Slot RF Modules
Remove Module B Shelf for
Dual-Slot 40W RF Modules
IfyouareinstallingaDual‐BayRFModule,you
mustremoveamodulebayshelffromthePRU
chassistoaccommodatethemodul
e’ssize.(For
furtherinformation,seeTable10onpage15.)
RemovetheshelfasappropriatefortheRF
Mo
dule:
• F
oraLegacyDual‐Bay40WRFModule,when
installingintheAandBBays,removethe
ModuleBBayShelf.
• Fo
raDual‐BayRFModule,wheninstallingin
theCandDBays,removeModuleDBayShelf.
ToremoveaModuleBayShelf:
a Usea
9/64”Allen
™
wrenchtoremovethe
threescrewsthatattachthemoduleshelfto
thePRUchassis,asshowninthefollowing
graphic.
b Discardorstore
themoduleshelfand
fasteners.