User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
FlexWavePrismRemoteUnitRFModuleInstallationGuide Page11
TECP‐77‐141Issue6 • 300001744178RevF • July2014 ©2014TEConnectivity
RFMODULECOMPONENTS
Figure5showstypicalRFModulecomponents,usingtheSingle‐BayRFModuleasanexample.
Mounting
latch
Mounting hook
Duplexer
Power Amplifier (PA)
DARTs
NOTE: The RDI is internal to the RF Module and is therefore not shown.
LNA
(inside the Duplexer cavitiy)
Figure5.Single‐BayRFModuleComponents
Figure6showsthecomponentsofanHDMRFModule.
Duplexers
Power Amplifier
Mounting latch
Mounting hook
Tx and Rx Cards
DPM
Figure6.HDMRFModuleComponents