User's Manual
Table Of Contents
- Preface
- Overview of RF Modules for Prism Remote Units
- Install the RF Module(s)
- Safety Precautions
- Guard Against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Slot Modules Only—Remove the Module Slot Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Contacting TE Connectivity
Tie wrap around
factory-installed
RX1 cable
Keep cable bends
behind the edge
of the Connector
Interface Panel
Connect the RF Module Cables
FlexWave Prism RF Modules for Prism Remote Units Installation Guide Page 41
TECP-77-141 • Issue 1 • April 2012 © 2012 TE Connectivity Ltd.
Figure24.Cable Connections for Dual-Slot 40W RF Modules
14 EnsurethatallcablebendsarebelowthetopedgeoftheConnectorInterfacePanelas
indicatedbythedashedlineintheprecedingfigure.Failuretocorrectlypositionthecables
couldinhibitclosingthePRUdoor,whichcanresultindamagetothecables.