User's Manual

Overview of RF Modules for Prism Remote Units
Page 12 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2012 TE Connectivity Ltd TECP-77-141 • Issue 1 • April 2012
RFModuleCablesforDual‐SlotInstallations
ForDual‐Slotinstallations,theRFcablesandconnectorsarelabeled
asMODNTX0/RX0andMODN
TX1/RX1
,whereNreferstothebottomslotofthedouble‐slotinstallation.Forexample,fora
Dual‐SlotinstallationinaQuad‐Bandchassis,theRFcablesandconnectorsarelabeledas
MODC
TX0/RX0
andMODCTX1/RX1.
Thecablesandconnectorshavecorrespon
dinglabelsasshowninTable7onpage12for
Dual‐Slot40WRF
Modules.
Table7. RFAntennaLabelsforDual‐Slot40WRFModules(TopofChassisDown)
RF Module
Cable,
RF Module
Connector,
and Remote
Antenna
Connector
Labels
Function
Slots for 40W RF Modules
(a) (b)
Dual-Band Tri-Band Quad-Band
Mod D
TX0/RX0
Transmit RF power and primary receive
to/from the antenna for RF Module D
N/A N/A Slots C and D
Mod D RX1 Diversity receive for RF power from the
antenna for
RF Module D
Mod C
TX0/RX0
Transmit RF power and primary receive
to/from the antenna for RF Module C
N/A N/A
Mod C RX1 Diversity receive for RF power from the
antenna for RF Module C
Mod B
TX0/RX0
Transmit RF power and primary receive
to/from the antenna for RF Module B
Slots A and B Slots A and B Slots A and B
Mod B RX1 Diversity receive for RF power from the
antenna for RF Module B
Mod A
TX0/RX0
Transmit RF power and primary receive
to/from the antenna for RF Module A
Mod A RX1 Diversity receive for RF power from the
antenna for
RF Module A
(a)
N/A indicates that the slot cannot be used for a Dual-Slot 40W RF Module
(b)
Install the Dual-Slot 40W RF Module in the lower-most slot in the chassis. If, however, if two Dual-SLot
40W RF Modules are present, install the 2100 Module in the lower-most slot and the 1900 Module in the
upper-most slot.