Installation Guide

Power on the RF Module
FlexWave Prism RF Modules for Prism Remote Units Installation Guide Page 45
TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013 © 2013 TE Connectivity Ltd.
PowerontheRFModule
1 FollowtheruleslistedbelowtotogglethePowerswitchthatcorrespondstotheRFModule
toitsONposition.
• ForDual‐SlotRFModules,usethePowerswitchforthelowermodule.Forexample,to
powerupaDual‐SlotRFModuleincombinedslotsC+DinaQuad‐Baychassis,turnONDC
PowerswitchforModC;leavetheDCPowerswitchforModDOFF.
• ADual‐Slot40WRFModuleusesthePowerSuppliesinbothslots.IftheDual‐Slot40WRF
ModuleisinstalledinslotsC+D,turnONthePowerswitchforModCandModD.
2 Repeatallthestepsin“InstalltheRFModule(s)”onpage21toinstallotherRFModules.
MOD A
SeRF
Module
AC Power
switch for
Remote
chassis
DC Power switch for Mod A
DC Power switch for Mod B
DC Power switch for Mod C
DC Power switch for Mod D
MOD B
MOD C
MOD D