Installation Guide
Table Of Contents
- Preface
- Overview of RF Modules for PRUs
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Slot Modules Only—Remove the Module Slot Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Contacting TE Connectivity
Install the RF Module(s)
Page 44 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2013 TE Connectivity Ltd TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013
Figure24.Cable Connections for Dual-Slot 40W RF Modules
CAUTION! EnsurethatallcablebendsarebelowthetopedgeoftheConnectorInterfacePanelasindicated
bythedashedlineintheprecedingfigure.Failuretocorrectlypositionthecablescouldinhibit
closingthePRUdoor,whichcanresultindamagetothecables.
Tie wrap around
factory-installed
RX1 cable
Keep cable bends
behind the edge
of the Connector
Interface Panel