Installation Guide
Table Of Contents
- Preface
- Overview of RF Modules for PRUs
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Slot Modules Only—Remove the Module Slot Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Contacting TE Connectivity
Connect the RF Module Cables
FlexWave Prism RF Modules for Prism Remote Units Installation Guide Page 39
TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013 © 2013 TE Connectivity Ltd.
RefertothegraphicthatcorrespondstotheRFModulebeinginstalledintoasingleslot(bay)
ofthePRU:
• Single‐SlotRFModule:Figure21onPage39
• HDMRFModule:Figure22onpage40
Figure21.Cable Connections for Single-Slot RF Modules
CAUTION! EnsurethatallcablebendsarebelowthetopedgeoftheConnectorInterfacePanelasindicated
bythedashedlineintheprecedingfigure.Failuretocorrectlypositionthecablescouldinhibit
closingthePRUdoor,whichcanresultindamagetothecables.
MOD A
MOD D
MOD C
MOD B
SeRF
Module
TX0/RX0
RX1
DIV
PRIM
PWR
Note routing of
high-speed cables
Note bend
radii ≥ 1-inch
Edge of Connector Interface Panel
Cable connections for a Single-Slot RF Module