Installation Guide
Table Of Contents
- Preface
- Overview of RF Modules for PRUs
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Slot Modules Only—Remove the Module Slot Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Contacting TE Connectivity
Preface
Page 2 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2013 TE Connectivity Ltd TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013
PREFACE
ThismanualprovidestheinformationyouneedtoinstallTEConnectivityFlexWavePrism
®
RF
ModulesintoaPrismRemoteUnit(PRU).Installationinstructionsareprovidedforthefollowing
PrismRemoteUnitRFModules:
• Single‐SlotRFModules,whichincludestheHDMRFModules
• Dual‐SlotRFModules
– Dual‐CardRFModules
–40WRFModules.
NOTE: ThisinstallationguidedocumentstheRFModulesthatarecompatiblewiththeFlexWavePrism
RemoteUnit,whichisdesignedforoutdooruse.ForinformationontheRFModulesdesignedfor
usewiththeFlexWavePrismIndoorRemoteUnits(IRUs),seethe FlexWavePrismIndoorRemote
UnitInstallationGuide(TECP‐77‐197).
RevisionHistory
Table 1. Revision History
Issue Document Date Technical Updates
1 April 2012 Original
2 February 2013 Changed Prism remote Unit model names from Single-/Dual-/Tri-/Quad-Band to
Single-/Dual-/Tri-/Quad-Bay; updated
Table 4 on page 10 to add new RF Modules; removed the
Specifications section, which included the RF and Optical Specifications and the Frequency and
Composite Output Power at Antenna Port (dBm) for Prism Remote Units tables; to access these
performance specifications, refer to the FlexWave Prism Performance Specifications (TECP-77-201);
updated
“Contacting TE Connectivity” on page 46.
3 May 2013 Updated “Accessing User Documentation on the TE Customer Portal” on page 4; added
“Understanding the RF Module Cables” on page 15; updated “Connect the RF Module Cables” on
page 37.
4 October 2013 Added support for the following HDM RF Modules, in conjunction with Prism EMS Software Release
8.1.1: HDM AWS Band 4 MIMO 20W; HDM AWS Band 4 SISO 40W; HDM PCS Band 25 SISO 40W
(see
Table 4 on page 10); updated Table 2 on page 3.
5 November 2013 Adds support for the